Angie’s List

Basement FinishingTo place the highest plate, tape your stage to a straight 2×4 and mark the blocks or joists at either finish of the wall. It is a simple matter to frame or fur out around projections and then drywall and finish them to blend in with surrounding surfaces. You can even search near a city, place, or deal with instead. In a basement, the top and backside plates are sometimes different lengths.

Your plan ought to embrace wall dimensions, window and door sizes, and each room’s purpose (e.g., family, bed room, etc.) along with any particular options like fireplaces. Snap chalk lines four in. away from the insulation on the exterior walls. For those who need future entry to something, just frame round it and reduce out the opening once you drywall (Photo 1). Then, after taping and portray, screw a return air” grate over the opening to hide it but still have entry.

Likewise, it’s easier to predrill and drive concrete screws fairly than pound in concrete nails when fastening bottom plates. On the high of your Opera window, near the web handle, you must see a grey location pin. Try once more later, or search close to a metropolis, place, or handle instead. That is as a result of high plates might undertaking past basis partitions and be longer or run into soffits and be shorter.

When you have plenty of deep projections from the ceiling or you need plenty of entry, consider installing a suspended ceiling relatively than drywalling. Snap a chalk line 2 in. below the bottom portion of ductwork or piping and nail a 2×four to the wall studs at that point. Mark each side of partition partitions with chalk lines, then middle and nail 2×6 backer boards in walls that they be a part of.

Then lower 2×four bottom and prime plates and lay out stud areas every 16 in. on every plate. Nail 2×4 blocking about each three ft. into the primary floor joist to support the highest plate. If partitions run parallel to flooring joists, you will have to nail or screw blocking in between the floor joists about every three ft. or so (Picture 5). For many, working in screws is easier than overhead nailing.

Leave a Reply